Commercial, Office, Pubs

Infrared thermography is the ability to see defects and energy loss from your building or home.

State-of-the-art thermal imaging equipment literally takes a picture of energy. So if you are looking for a fast in-expensive, non-destructive solution - you have come to the right place!

This is often a good starting point as it can show where energy saving measures should be focussed and what should be undertaken. Uniquely the costs associated with a particular defect can be quantified in terms of cost per annum.

You will receive a clear, concise thermographic survey in one day and an analytical report within 5 working days. So it just couldn’t be easier to see precisely why top building surveyors use this technique to idemtify energy loss and save money.

Over 14,000 houses have been surveyed for insulation analysis.
The survey costs £1,100 per day and most buildings can be surveyed in a day. Analysys costs £600 per day and two days are required for each survey day undertaken.

Please email info@doctor energy.co.uk or call us on 0845 310 2731 to discuss your requirements further

More Information

LightPro is an intelligent controller for saving power on lighting loads. It reduces power
used by fluorescent, high bay and discharge lighting normally by 30% with a minimal effect on
light level, achieving a payback of 12-24 months depending upon usage and electricity cost

Savings of around 25-30% are readily achieveable in most environments, with some cases showing as high as 40%. Lighting levels will be effected, but in most cases only a little.
LightPro units are capable of saving around 20% with very little change to the lighting levels.
More Information

The Technology Explained

Refrigeration motors are only under maximum load when they begin to circulate coolant. After that they do not need the same power. But an uncontrolled motor will keep on drawing maximum power. Many systems are designed with unnecessarily large motors to provide a safety margin, and so produce even more waste.

SavaControls constantly monitor the motor load by comparing relative phase angles and the back emf. At part load, the apparent voltage to the motor is reduced by cutting the power up to 100 times every second reducing magnetisation losses and drawing much less current. A range of units are available, including single and three phase controls to handle up to 250 amps per phase.

An early report from the Cranfield Institute of Technology stated: "The results of these tests showed a considerable reduction in the power consumption in a low load situation... The maximum reductions observed approached 40%." However, since then, there have been a significant number of tests and site data logged results that show savings in the range 12-50% depending on circumstances.

Other tests have shown reductions of as much as 50% in electricity consumption, depending on the installation, averaging 20% on single phase, and 15% on three phase systems. When these figures are converted into cash, the advantages of SavaControls if your business uses refrigeration equipment, energy costs are likely to be one of your major overheads. Now SavaControls, the award winning energy saving electronic control systems for commercial refrigeration, can give you substantial and continuing savings in your electricity bills, without replacing your existing equipment.

To date SavaControls are saving its users well over £10 million worth of electricity per year. Over 700,000 of these widely acclaimed units have been installed by public authorities etc., and by thousands of independent retailers and caterers. This cost effective system reduces power consumption and prolongs motor life, therefore contributing to the efficiency of your organisation, whilst reducing waste of the Earth’s finite resources. That's a reduction of over 25,000 tonnes in CO2 emissions into the atmosphere every year!
Additional Benefits

Dries hands in UNDER 12 SECONDS
3 times faster than ANY other dryer
82% cheaper to run than ANY other dryer

The Xlerator hand dryer is the fastest and most effective hand dryer in the world. Not only does it offer an efficient alternative to paper towels it also out performs every other warm air hand dryer on the market.

When taken in conjunction with the time savings the Xlerator uses 82% less energy and is therefore 82% cheaper to run than any other hand dryer, and some 99% cheaper than paper.

The Xlerator hand dryer can be found in schools, hospitals, airports, restaurants, stadiums, cinemas, health clubs, offices, hotels and other public washrooms around the world. It comes in chip resistant, white epoxy paint or electroplated chrome to suit your restroom design and is easy to install and maintain.

Simply put you cannot buy a better warm air hand dryer than the Xlerator.

We understand that one of the most important factors in choosing a hand drying method is cost. To assist in your decision we have put together a cost comparison so you can see how the twin benefits of using less energy and taking less time combine to provide a real financial advantage.


The Xlerator hand dryer:
- is 3 times faster than any other hand dryer on the market;
- uses 82% less energy than conventional dryers; and
- is one of the most reliable hand dryers you can buy

Making it the best hand dryer choice whichever way you look at it. It's efficient, it offers user satisfaction and also saves you money.

Because the Xlerator uses specially developed technology and a unique design it is a better hand dryer that only draws 1.4 kilowatts of electricity compared to 2.3 kilowatts or higher of other conventional dryers

Dries hands in UNDER 12 SECONDS
3 times faster than ANY other dryer
82% cheaper to run than ANY other dryer

The Xlerator hand dryer is the fastest and most effective hand dryer in the world. Not only does it offer an efficient alternative to paper towels it also out performs every other warm air hand dryer on the market.

When taken in conjunction with the time savings the Xlerator uses 82% less energy and is therefore 82% cheaper to run than any other hand dryer, and some 99% cheaper than paper.

The Xlerator hand dryer can be found in schools, hospitals, airports, restaurants, stadiums, cinemas, health clubs, offices, hotels and other public washrooms around the world. It comes in chip resistant, white epoxy paint or electroplated chrome to suit your restroom design and is easy to install and maintain.

Simply put you cannot buy a better warm air hand dryer than the Xlerator.

We understand that one of the most important factors in choosing a hand drying method is cost. To assist in your decision we have put together a cost comparison so you can see how the twin benefits of using less energy and taking less time combine to provide a real financial advantage.


The Xlerator hand dryer:
- is 3 times faster than any other hand dryer on the market;
- uses 82% less energy than conventional dryers; and
- is one of the most reliable hand dryers you can buy

Making it the best hand dryer choice whichever way you look at it. It's efficient, it offers user satisfaction and also saves you money.

Because the Xlerator uses specially developed technology and a unique design it is a better hand dryer that only draws 1.4 kilowatts of electricity compared to 2.3 kilowatts or higher of other conventional dryers